Rockbox Archos Recorder 6 Especificaciones descargar pdf (Pagina 115)

Chapter 11. Plugins 115

Figure 11.43: The Split Editor’s Main Screen

The Split Editor’s Main Screen

The waveform displays the volume of the song over time. It will appear as the song

plays and help to visually identify the point in time where the split is desired

The split point indicator is a vertical line with a small triangle at the top end. It is the

most important control element of the split editor. It can be moved with the Left

and Right buttons. Later, when you have ﬁne tuned the split point, the song will

be split at this position.

The split time At the top of the window a time value is displayed. This is the point in

time within the song at which the split point indicator is positioned.

The locator Another vertical bar represents the position locator. It moves along as the

song plays. In contrast to the split point indicator it has no triangles at the ends.

The time bar displays the current position within the song relative to the whole song.

The entire length of the time bar represents the song length. The length of the

solid part of the time bar represents the position and length of the displayed part

of the song.

The scale mode On the right side of the bottom line the scale mode is displayed. The

waveform can be scaled either logarithmically or linearly. In logarithmic scale mode

the letters “dB” are displayed, in linear mode “%”. Use F3 to switch between

these modes. Linear mode usually gives better optical hints with commercially

recorded music. For quiet recordings, especially of human speech, the logarithmic

scale often is preferable. More information in the Scale section 11.4.14 (page 117)

below.

The loop mode In the middle of the bottom line the loop mode icon is displayed. There

are 4 diﬀerent loop modes. Pressing F2 changes to the next loop mode.

Playback loops around the split point indicator. This mode is best used when

searching and zooming for the desired point at which to split the recording.

Playback loops from the split point indicator to the end of the visible area.

This mode is best used when ﬁne tuning the split indicator position at the

beginning of a recording.

The Rockbox manual Archos Recorder

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 166 167

Sin comentarios

Rockbox Archos Recorder 6 Especificaciones Pagina 115